Filter
Top Products
4
3,7
5
3,7
~
.——
.--”
The Al edit recording function enables CD recording without
worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track length,
If necessary, the order of tracks is rearranged so that no track is
cut short.
(Al: Artificial Intelligence)
m
AI edit recording will not start from a point halfway into the tape,
The tape must be recorded from the beginning of either side.
1
2
3
4
5
Insert the tape into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and load the disc(s).
Press EDIT/CHECK once while pressing
on the remote control.
“EDIT appears.
EDIT
SHIFT
c When “PRGM” is displayed, press EDIT/CHECK while
pressing SHIFT again.
Press DISC DIRECT PLAY 1-3 to select a disc.
Press numbered buttons O-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press 6 and O.
In a few seconds, the tracks to be recorded on each side of
the tape are determined.
● +, * or MULTI JOG are also available to designate
the tape length.
Tape length
Remaining time Programmed
of recording
tracks for side A
6
7
8
Press
● REC/REC MUTE to start recording on
the first side.
The tape is rewound to the beginning of the first side, the
lead segment is played through for 10 seconds, and recording
starts. When the last track programmed for side A is finished,
deck 2 enters the recording stop mode. After entering the
recording stop mode, go to step 7,
Press EDIT/CHECK while pressin!g SHIFT on the
remote control to display the program for the
second recording.
“B” is displayed.
Turn over the tape in deck 2 and press ● RECY
REC MUTIE to start recording on thie second side.
To stop recording
Press ■ . Recording and CD play stolp simultaneously.
To clear the edit program
Press ■ CLEAR twice sothat “EDIT disappears on the display.
To
check the order of the programmed track numbers
Before recording, press EDITICHECK while pressing SHIFT on
the remote controlto select side A or B, and press + or E
repeatedly.
F’rogrammed
Track number track numbers
Program number
To add tracks from other discs tc~the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment .
1 Press
EDITICHECK while pressing SHIIFT on the remote
controlto select side A or B.
2 Press DISC DIRECT PLAY 1-3
to select al disc.
3 Press numbered buttons on the remote
conitrolto select tracks.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recordingtime is usually a little longerthan
the specified recordingtime printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape’s specified recording time
after editing, the display shows the extra time (without a minus
mark), instead ofthe time remainingcmthe tape (withthe minus
mark).
The Al edit recording function cannot be used with discs
containing 31 tracks or more.
*CD EDIT/CHECK on the unit k also available instead of EDIT
CHECK on tha remote control.
Tape side
A: First recording side
B: Second recording side
ENGLISH
14