Filter
Top Products
6 ENGLISH
1 Press *TUNER/BAND repeatedly to
select the desired band.
FM AM
The power is turned on and the previously tuned
station is received.
* or BAND on the remote control
2 Press r, t (TUNING f -, + g)
to select a station.
During FM stereo reception, “STEREO” is
displayed.
After listening, press POWER 6STANDBY/ON to
turn the power off.
For better reception
• When connecting an FM outdoor antenna, see
“Connecting antennas” on page 4.
For quick tuning (Auto Search)
Keep r, t pressed until the tuner starts
searching for a station. When a station is tuned to, the
search stops.
If the broadcast signal is weak, it does not stop. To
stop the search manually, press r or t.
TUNER OPERATION
A
When an FM stereo broadcast contains noise
Press MODE on the remote control so that “MONO” is
displayed.
Noise is reduced, although reception is monaural.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/
step. If you use the unit in an area where the frequency
allocation system is 9 kHz/step, change the interval as
follows.
1 Press TUNER/BAND.
2 Press POWER 6STANDBY/ON while pressing
TUNER/BAND.
When the AM tuning interval is changed, the preset
stations are cleared.
NOTE
If the unit picks up noise from other electrical
appliances nearby, like a TV or fluorescent lights, move
the unit.
To listen with the headphones
Connect headphones with a stereo mini plug to the
PHONES jack.
POWER
6STANDBY/ON
a PAUSE/SET
PHONES
s
r, t
d PLAY/DIR/PRESET
T-BASS,
QSURROUND,
3-MODE EQ
TUNER/BAND
VOLUME/TIMER
Extend the rod antenna
and orient it for the best
reception.
Rotate the AM loop
antenna to find the best
reception.
AMFM