Filter
Top Products
VOLUME
Press VOLUME A or V. The volume level is displayed
as a number from Oto MAX (25).
● The volume level is automatically set to 14 if the power
is turned off when the volume level is set to 15 or more.
To display the volume level when a function other than
TAPE function is selected
Press VOLUME
A or V. The volume level is displayed
for 4 seconds.
DISPLAY on the remote control is also available.
3-MODE EQUALIZEI?
Press * 3-MODE EQUALIZER until one of the indicators
lights up.
The equalizer mode changes to ROCK, POP, JAZZ or no
equalization, cyclically.
ROCK - Emphasizes the high and low range of music.
POP - Emphasizes voice and midrange of music.
JAZZ - Emphasizes the low range of music.
* or EQ on the remote control
T-BASS system
The T-BASS system enhances the realism of low-
frequency sound.
Press T-BASS and the T-BASS indicator lights up.
QSOUND system
This system provides a rich, three dimensional sound area
for stereo sources.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up.
c At higher volumes, turning QSOUND on may cause
sound distortion. In this case, turn the volume down.
If an erroneous display or malfunction occurs
Make sure that none of the deck operation buttons is
pressed.
Press 9 while pressing POWER (!) STANDBY.
If the unit cannot be reset in the way above, disconnect the
AC cord and remove all the batteries to turn off the display.
Leave the unit for a while and turn the power back on.
The unit can be turned off automatically at a specified time.
● While CD function is selected, operate the following
procedures in stop mode.
Press REPEAT/FM lVIODE/OSC ~=d while
pressing STOP/MEMORY ~.
If STOP/MEMORY is kept pressed, another operation
may start.
Within 4 seconds, press [++ or M to specify
the time until the power is turned off.
Each time it is pressed, the time changes between 10
and 90 minutes in 10-minute steps.
Specified time
While the sleep timer works,
the dot keeps flashing.
To check the time remaining until the power is turned off
Repeat step 1 shown above. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Display the remaining time and press M or *I
repeatedly until OFF is displayed.
NOTE
If the unit is turned off during tape playback, + on the deck
will not be released. Press WA to release +.
Maintenance
To clean the cabinet
Use a soft cloth lightly mclistened with mild detergent
solution. Do not use strong solvents such as alcohol,
benzine or thinner.
To clean the heads
When the tape heads are dirty;
- high frequency sound is not emitted
- the sound is not adequi~tely high
- the sound is off-balance
- the tape cannot be erased
- the tape cannot be recorded on
After every 10 hours of use, clean the tape heads with a
head cleaning cassette.
Use separately sold dry-type or wet-type cleaning
cassette.
Refer to the instructions c)fthe cleaning cassette for
details.
To clean the lens
Use a cotton swab slightly
moistened with cleaning fluid.
Wipe gently from the center to
the edge.
Lens
ENGLISH ~