Filter
Top Products
MANUAL TUNING
1
2
I
1
2
TUNER MODE/
Osc
Press TUNER/BAND repeatedly to select the
desired band.
~FM+AM~
When TUNER/BAND is pressed while the power is off,
the power is turned on directly and the previously tuned
station is received (Direct Play Function).
When using the remote control, press BAND repeatedly
while the power is on.
Press 44 DOWN or FF UP to select a station.
Each time the button is pressed, the frequency changes.
During FM stereo reception, STEREO is displayed.
To search for a station quickly (Auto Search)
Keep + DOWN or - UP pressed until the tuner starts
searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press + DOWN or ~
UP.
● The Auto Search may not stop at stations with very weak
signals.
For better reception
FM
Extend the FM antenna and orient it for the best reception.
AM
The AM antenna is inside the unit. Position the unit for the
best reception.
%, a
A
FM
When an FM stereo broadcast contains noise
Press TUNER MODE/OSC.
MONO appears on the display,
Noise is reduced, although reception is monaural.
MODE on the remote control is also available.
To restore stereo reception, press the button again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step.
If you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNER/BAND.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations
(see PRESETTING STATIONS) are cleared. The preset
stations have to be set again.
6 ENGLISH