En
ENGLISH
7
AUDIO ADJUSTMENTS
VOLUME
Turn VOLUME on the main unit, or press VOL on the
remote control.
The volume level is displayed as a number from 0 to MAX (31).
The volume level is automatically set to 16 when the power is
turned off with the volume level set to 17 or more.
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press T-BASS.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
To select with the remote control
Press T-BASS while pressing SHIFT.
Low frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low frequency sound is originally
emphasized. In this case, cancel the T-BASS system.
SETTING THE CLOCK
Use the remote control.
1
Press CLOCK while pressing SHIFT.
When using the unit, press a while the power is off.
The clock is displayed. (The “:” between the hours and minutes
flashes.)
2
Within 4 seconds, press f or g to designate
the hour and the minute.
Pressing either button changes both the hour and the minute.
Holding it down will vary the time rapidly by 10-minute interval,
and pressing it repeatedly will vary by 1 minute interval.
3
Press a.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK while pressing SHIFT before completing step 3
to restore the previous time setting. This cancels any new setting.
To view the clock when another display is in the display
Press CLOCK while pressing SHIFT. The time is displayed for 4
seconds and then the original display reappears. However, the
clock cannot be displayed during recording.
To switch to the 24-hour standard
Press CLOCK while pressing SHIFT and then press s within 4
seconds.
Repeat the same procedure to restore the 12-hour standard.
In the 12-hour standard, “AM 12:00” indicates midnight and
“PM12:00” indicates noon.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the removal
of the power cord. The current time needs to be reset.
If the power-economizing mode (page 6) is on, the unit blacks
out when the power is turned off. To view the clock, press CLOCK
while pressing SHIFT so that the time is displayed for 4 seconds.
PREPARATIONS
SOUND
SOUND