Aiwa TS-W45 Speaker System User Manual


 
FRONT
I
3—) REAR
1
(3
VOLUME
OPERATION
ADJUSTING THE VOLUME BALANCE
;g-q:
,&%i~
Adjust the volume balance between the powered subwoofer and
1$
the left and right speakers of the connected stereo system.
la-,-
1
Press the POWER button.
r.+,..:
g~~st
The indicator above the button lights up.
,:6.&
.....
2 Start playback on the connected stereo system.
a=”q
.7,,&
,,*.%
3 Adjust the volume of the powered subwoofer.
!,,,*
-,“,.~j
~z!%
.,
~... Moderate volume setting
To get natural bass sounds, adjust the volume of the powered
subwoofer according to its position and the graphic equalizer
setting of the stereo system.
Adjustment examples
@
Set the VOLUME control to a little lower than the middle when
the subwoofer is
placed on the floor and the graphic equalizer
is set to off.
@ Set the VOLUME control to the middle when the subwoofer is
positioned higher than the floor and the graphic equalizer is
set to off.
m
To avoid overloading the powered subwoofer, do not set the
volume of the stereo system so high that the sound is distorted.
Low frequency sounds may be distorted when they are
emphasized by the graphic equalizer on the stereo system. Adjust
the VOLUME control on the powered subwoofer or the graphic
equalizer on the stereo system.
If the powered subwoofer will not be used for a long period of
time, press the POWER button to turn off the power, and unplug
the AC cord from the wall outlet.
CHANGING THE PHASE +
Depending upon the room or the characteristics of the right and
left speakers, sound from the powered subwoofer may seem
unnatural or unusually loud or soft.
In this case, try changing the PHASE switch setting. Set to the
NORMAL or REVERSE position, whichever sounds better.
USINGTHE AUTO POWER FUNCTION+
Before using this function, make sure the POWER button is set to
ON.
While the AUTO POWER switch is set to ON, the power is
automatically turned on when receiving a signal input from either
INPUT 1 or INPUT 2.
The power is automatically turned off if no signal is input for a
while and the indicator of the POWER button becomes dimmer, If
input signal is too weak, this function does not effect.
While the AUTO POWER switch is set to OFF, the power is turned
on or off by pressing the POWER button.
8