Acoustic Research AWD204 Headphones User Manual


 
Ge t t I n G St a r t e d
5
To charge the headset unit:
Plug the transmitter’s built-in charging
cable (located on the back of the
transmitter) into the Charge jack on
the left headphone. (Make sure the
transmitter is plugged in!)
While the headphones are charging, the
Charge indicator on the transmitter’s
front panel remains red.
Charging the Headset
If you use the rechargeable batteries provided with the headphones,
you should charge them before you use them for the rst time.
The batteries charge when the headphones are connected to the
transmitter’s built-in charging cable.
WARNING: To avoid risk of re or injury, DO NOT connect the
headphones to the transmitter with the charging cable if you installed
alkaline or other non-rechargeable batteries – this could cause the
batteries to leak, which would damage the headphones.
Transmitter
(back panel)
Left headphone
Built-in
charging
cable
Notes about charging:
When the batteries are charged, remember to unplug the charging
cable from the headphones and transmitter.
Never leave the batteries charging for more than 48 hours.
The batteries should be charged for a full 15 hours.