Filter
Top Products
7
Speaker Back View
Speaker Power
Input Jack
Left/Mono/Right
Slide Switch
Turning the Speakers Off
1. Press and hold the Power/Volume / Scan control to turn the speaker off.
2. Conrm that the speaker is off by verifying that the STDBY./TUNED indicator
is no longer illuminated.
The speaker will automatically charge rechargeable batteries (NiMH or NiCd
only) when the batteries are installed and the speaker is plugged in with the AC
power adapter. The CHRG. indicator on the front of the speaker will illuminate.
Warning: DO NOT power the speaker with the AC power adapter if you installed
alkaline or other non-rechargeable batteries – this could cause the batteries to leak,
which would damage the speaker.
3. Set up each speaker for mono or stereo operation.
a) Monaural operation: The monaural mode
(MONO) is recommended when using single
speakers separately. For monaural operation, set
the L/MONO/R switch to “MONO” on each
speaker.
b) Stereo operation: Set the L/MONO/R switch
to “L” on the speaker located to the left from
the listener, and set the other speaker to the “R”
position.
Notes:
Each speaker automatically retunes if it loses the
transmitter’s signal. You can also press the Power/
Volume/Scan button on the front of the speaker to
retune the speaker at any time.
The transmitter turns off automatically if there is no
audio signal present for a prolonged period.
Interference in the form of static and/or distortion
can sometimes be heard. If this occurs, conrm the
transmitter/speaker adjustments and indicators. If the
problem persists, refer to the Troubleshooting section of
this manual.