Filter
Top Products
A80/P80
6
English
A80/P80
7
Recording
With the Arcam A80 it is possible to listen to and record from
one source, or to listen to one source while recording another.
Both sets of tape sockets are identical in sensitivity and suitable
for use with almost any type of recorder (cassette, CDR, MD,
VCR, reel-to-reel, etc.). The record signal is sent to both the
TAPE and VCR output sockets.
RECORD
To record the currently selected source, press RECORD until
the display shows ‘REC SOURCE’. After a few seconds the
display reverts to showing the volume level and you are ready
to record.
To listen to one source while recording another, press RECORD
again until the display shows ‘RECORD’ followed by the name
of an input (e.g. ‘AUX’, ‘CD’, ‘TUNER’, etc.). Now press the
source selector button on the front panel for the source you
wish to record. Your selection is shown on the display for a few
seconds, after which it reverts to showing the volume level and
you are ready to record.
The RECORD button can also be used as a second zone
selector, sending a source signal at line level to a second
amplier operating in another room. If you need help with this,
contact your Arcam dealer or Arcam customer support.
Tape-to-tape copying (dubbing)
You can perform tape dubbing from VCR to TAPE, but not from
TAPE to VCR.
For example, to copy from a cassette recorder connected to
the VCR socket to a cassette recorder connected to the TAPE 1
socket, rst use the RECORD button as explained above and
select ‘RECORD VCR’. This routes the VCR signal to the TAPE
output.
Set the cassette recorder connected to the TAPE socket into its
record mode and the other to playback mode to start dubbing.
TAPE
5
To play back the recording from a cassette deck attached to
the TAPE 1 input, press TAPE. ‘TAPE 1’ is shown on the display.
Selecting this input overrides the other source selectors.
It is also possible to monitor a recording while it is being made,
provided your cassette deck is a 3-head type. To do this, press
TAPE. Switching this button in/out allows an A/B comparison
between the source signal and the recorded signal.