Filter
Top Products
9
ENGLISH
© 3M 2009. All rights reserved.
Product Warranty and Safety Guide3M™ Digital Projector X30N/X35N
CAUTION
• To reduce the risk associated with environmental contamination:
- Dispose of exhausted batteries in accordance with applicable federal, state, and
local regulations.
• To reduce the risk associated with explosion, and/or chemicals from a leaking
batteries:
- Use only with battery type AA (HITACHI MAXELL Part No.LR6 or R6P).
- Orient the battery's plus (+) and minus (-) terminals of the batteries according to
the markings found on the remote control or internal clock battery case.
- Do not leave the battery in the remote for an extended period of time.
- Do not heat, disassemble, short, recharge, or expose to re or high temperature.
- Do not carry batteries loose in your pocket or purse.
- Avoid eye and skin contact in the event that battery would leak.
- Do not mix used and new batteries.
- Obey the local laws on disposing the battery.
• To reduce the risk associated with the impact of a falling projector:
- Use only the 3M™ brand wall/ceiling mounting hardware kit if wall or ceiling
mounting is desired.
- Installation of the 3M™ wall/ceiling kit must only be performed by qualied personnel.
- Adhere strictly to the proper installation procedure as outlined in the installation
instructions when installing the 3M™ wall/ceiling kit.
- Always operate the unit on a at, sturdy, and horizontal surface.
• To reduce the risk associated with intense visible light:
- Avoid looking directly into the projector lens while the lamp is on.
• To reduce the risk associated with tripping and/or impact:
- Position the power cord and data cable so that they cannot be tripped over.
• For safety, do not connect the LAN port to any network that might have
excessive voltage.