Filter
Top Products
4
Instructions for XT-1 Headset
Controls and Battery Charging
Headset Controls
Removing Batteries
• Slide and hold the battery release.
• Remove the discharged battery from the battery housing.
• Insert a fully charged battery in the housing with the notch facing the battery
release. Make sure the battery is fully inserted (battery release clicks).
Charging Batteries
To charge a battery, insert the battery in one of the charging slots as shown.
• The indicator lights RED to indicate the battery is charging.
• The indicator lights GREEN to indicate the battery is charged.
• Charge batteries after every shift.
Headset Cleaning
• For good health and hygiene, every headset should be cleaned on a regular schedule.
• Before cleaning, remove the battery and the soft foam ear pad from the headset and
microphone windscreen — if used.
• Use a damp soft cloth to wipe the surfaces clean. We recommend using a
3M
™
5040/7065 Cleaning Wipe or a Scotch-Brite
®
High Performance Cloth.
• DO NOT soak the headset or immerse it in water; you might damage the electronics.
• DO NOT bend the microphone boom.
Adjustment Slide
Order
Taking Mode Listen Talk
Vehicle
Detector
Automatic
Standby
Order
Point
ML/PTT
Manual Push to Talk Presence On Used
ML/MLT
Manual Manual Latching Presence On Used
AL/PTT
Automatic Push to Talk Presence On Used
AL/MTT
Automatic Manual Latching Presence On Used
Hands Free
Automatic Automatic Presence On Used
Outside
Manual Manual Latching Ignored Off Not Used
Always On
Always On Manual Latching Ignored Off Used
Order Taking Modes
See your Manager to confirm which Order Taking Mode your headset is using.
Order Taking Mode Mode Description
Manual Listen
(ML)
• Headset beeps when vehicle is detected
• Tap Talk button to turn on Customer Order Point microphone and hear the customer
• Customer Order Point microphone stays on until vehicle departs
Push To Talk
(PTT)
• Push and Hold the Talk button to talk to the customer
• Release the Talk button to turn off microphone so customer cannot hear you (Mute)
Automatic Listen
(AL)
• Headset beeps when vehicle detected; no buttons to push — automatically hear the customer
• Customer Order Point microphone automatically turns on and stays on until vehicle departs
Manual
Latching Talk
(MLT)
• Tap the Talk button to talk to the customer
• Customer Order Point and Headset microphones stay on until you tap the Talk button again
or vehicle departs
Remove Replace
Indicator LED
• Green — Headset in Lane 1 Listen
• Amber – Headset in Lane 2 Listen
Volume Up
Page Button —Tap to Change Order Taker
Volume Down
Talk Button Lane 2
Talk Button Lane 1
Battery
Battery Charger
Charging Status
Indicator