Filter
Top Products
INDUCTION METHOD
Place the transmitter on the ground over the target cable with the lid hinge
in line with the cable path. Press
to turn the Transmitter on.
Press again to select either 33 kHz or 133 kHz. For greater tracing range,
select high output level by pressing
.
Note: If the Receiver is less than 15 meters from the Transmitter, it can
pick up signal through the air. For best results, keep the Receiver away
from the Transmitter by at least that distance.
Transmitter setup is finished, now go to LOCATING A BURIED CABLE
- R
ECEIVER SETUP (PAGE 10).
Page 9