17
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the
laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of the
water by using the following procedure.
Procedure:
Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons 3
and 6 until «
C0» appears on the digits.
Adjusting the level of
conductivity:
Press button 5 sequentially: the level of conductivity
is indicated by the lighting of the horizontal hyphens.
Normally, the appliance is factory-set to the
highest level; however, certain models may be
configured differently.
Memorising the new
setting:
Simultaneously press down buttons 3 and 6 until the
previous drying cycle time appears again on the
display and the buzzer sounds.
Display Conductivity degree
Approximative value
ºdH
CC 00
Low < 14
CC 00
Medium 15 - 21
CC 00
High > 21
