4-10
Odometer and tripmeter modes
Pushing the “TRIP/ODO” button switches the
display between the odometer mode “ODO”
and the tripmeter modes “A” and “B” in the fol-
lowing order:
ODO
→
TRIP A
→
TRIP B
→
ODO
To reset a tripmeter, select it by pushing the
“TRIP/ODO” button, and then push the “TRIP/
ODO” button for at least three seconds. The
tripmeters can be used to estimate the dis-
tance that can be traveled with a full tank of fu-
el. This information will enable you to plan
future fuel stops.
NOTE:
_
Holding in the “TRIP/ODO” button and then
turning the key to “ON” switches the display
between “mph” and “km/h”.
_
Clock mode
Pushing the “”/“” button switches the
display between the clock mode “CLOCK”
and the hour meter mode “HOUR” in the fol-
lowing order:
CLOCK
→
HOUR
→
CLOCK
To set the clock
1. Set the display to the clock mode.
2. Push the “”/“” button until the clock
starts flashing.
3. Set the hours by pushing the “H” button.
4. Set the minutes by pushing the “M” but-
ton.
5. Push the “”/“” button, and then re-
lease it to start the clock.
U5UG12.book Page 10 Thursday, June 23, 2005 9:02 AM
