8-6
6. Insert the dipstick into the oil filler hole,
and then tighten the engine oil filler cap.
Engine oil replacement and oil filter ele-
ment cleaning
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes
and stop it.
3. Place a container under the engine to
collect the used oil.
4. Remove the engine oil filler cap, and then
remove the drain bolt to drain the oil.
CAUTION:
_
When removing the drain bolt, the com-
pression spring, oil strainer and O-ring will
fall out. Take care not to lose these parts.
_
1. Drain bolt 2. O-ring
3. Compression spring 4. Oil strainer
U5NF12.book Page 6 Wednesday, May 8, 2002 11:11 AM
