A SERVICE OF

logo

5 - 91
ENG
c. Tighten the crankcase bolts further to reach
the specified angle 120° in the proper tight-
ening sequence as shown.
WARNING
When the bolts are tightened more than the
specified angle, do not loosen the bolt and
then retighten it.
Replace the bolt with a new one and per-
form the procedure again.
CAUTION:
Do not use a torque wrench to tighten the
bolt to the specified angle.
Tighten the bolt until it is at the specified
angle.
NOTE:
When using a hexagonal bolt, note that the
angle from one corner to another is 60°.
▲▲▲ ▲▲▲ ▲▲▲ ▲▲▲ ▲▲▲ ▲▲▲ ▲▲▲
T
R
.
.
Crankcase bolt
1 ~ 0
Final
Specified angle 120°
8. Tighten:
crankcase bolts A ~ U
NOTE:
@
Tighten the bolts in the tightening sequence
cast on the crankcase.
T
R
.
.
Bolt
A
,
B
24 Nm (2.4 m · kg)
Bolt
C
,
D
12 Nm (1.2 m · kg)
Bolt
E ~ U
10 Nm (1.0 m · kg)
CRANKCASE