To replace burners:
1. Slip
the air shutter over the gas valve
orifice.
2.
Lower
the burner assembly and
hook
the
tabs in the slots in the burner support.
3.
Be sure
both tabs are in their slots, that the
burner sits level and straight, and that the
flash tube forms a straight line from the
ignitor to the burner.
NOTE: Occasionally check
the burner flames
for proper size and shape as shown.
A gocd
flame is blue in color. If flames lift off ports, are
yellow, or are noisy when turned off, you may
need to clean the burners (see page 31) or
call a qualified technician for adjustment.
Ports
I
l”t-
.’ on no on0 ‘.
a!
Typical surface
burner
flame
at highest setting
Removing the oven bottom
The oven bottom can be removed to clean
large spills, but oven bottom must be replaced
before using the Self-Cleaning cycle.
Burn Hazard
Make sure all parts are cool before
removing.
Failure to do so could result in burns.
To remove:
1. Slide
the tab at the center front of the oven
bottom to the left.
2.
Lift
the oven bottom up and out.
‘To replace:
1. Slip
the oven bottom into the oven so the
tabs in the rear of the oven bottom fit into
the slots in the oven back.
Unlock
Lock
2.
Lower
the front of the oven bottom into
place and
slide
the front tab to the right to
lock the oven bottom into place.
NOTE:
See “Cleaning chart” on page 34 for
information on cleaning the oven bottom.
32
