Hold surface unlt level
wh:n replaclng.
Prop up the top with
support rod.
Remove screws; swing
out top. Lift up at
bottom.
Pull to stop. Lift; pull
again.
Replacins reflector bowls and surface units:
Be sure the surface unit controls are on “OFF.”
Put the reflector bowls back into their places. Make sure you can see
the plug-ins (receptacles) for the surface units through the square
hole in the side of each bowl.
Hold the surface unit level with the prongs (terminals) pointing at
the plug-in.
With the prongs started in the plug-in. start pushing In on the surface
unit. At the same time. lift a little on the side of the surface unit that’s
by the plug-in.
Make sure the surface-unit prongs are pushed into the plug-in as far as
they will go The surface unit should fit into the reflector bowl and be
level.
Cleaning under the cooktop:
To clean the area under the cooktop. lift the front of the cooktop at
the center Raise the swing-up rod to hold it. (Be sure the tip of the rod is
In the notch In the c ,ooktop.
Jse
warm
soapy
water and a spor ige ( x cloth
Scounng powders or any other abrasive cleaner may harm porcelain-
enamel finishes and can scratch chrome.
Be careful not to raise the cooktop so high that It touches the
control console. And don’t drop it. Dropping the cooktop can chip or crack
a hard porcelain finish. or damage side panels and surface units
Removing the outer oven window:
Oven windows have several panes of glass to help hold the heat In
the oven. The outer glass and frame can be removed if you wish to clean
between the two It is held on by screws at the top. and tabs hidden at the
bottom.
1 With the oven door closed. remove the screws from the top of the
outer window frame.
2 Tip the frame out about two inches (5 cm) from the door. (The
frame and glass are one piece. so don‘t worry about them
coming apart.)
3. Lift up on both sides of the frame to pull the tabs out of the slot at
the bottom of the window opening.
To replace the frame and glass, line up the bottom of the frame
with the opening in the door.
1 Tilt the frame so that the tabs fit into the slot at the bottom of the
window opening.
2 Tilt the frame as far as you can and push down.
3 Push the frame in the rest of the way and replace the screws.
Removing the storage drawer:
The drawer below your oven is meant to store pots and pans.
Never keep anything in there that will burn or melt.
You may want to remove the drawer for cleaning under the range.
Pull it straight out until It stops.
Use care when handling the drawer.
Lift
the front and pull some more to get it over the stop. Now slide it out until
It stops agaln Lift the drawer away from the range until it slips out of the
yudes
To put it back, fit the side rails at the back of the drawer into both
guides on the range. Push it closed while lifting the front to get past the
stops.
