Figure 1
3-PRONG
GROUNDING PLUG
II
\
0
\
Q
0
6
!’
GROUND 1
PRONG
3- PRONG
GROUNDING
\
TYPE WALL RECEPTACLE
POWER SUPPLY CORD
ALTERNATE GROUNDING
METHOD
If changing and properly grounding the wall
receptacle is impossible and where local codes
permit (consult your electrical inspector), a
temporary adapter may be plugged into the
existing 2-prong wall receptacle to mate with the
3-prong power supply cord. See Figure 2. THIS,
HOWEVER, IS NOT RECOMMENDED.
If this is done, you must connect the grounded
eyelet on the adapter to the wall receptacle
cover plate screw and from this same screw, you
must connect a separate copper ground wire
(#14 minimum) to a grounded cold water pipe.*
See Figure 2. Do not ground to a gas supply
pipe. Do not connect to electrical supply until
appliance is permanently grounded.
GROUND ASSEMBLY
TTACH TO GROUNDED
ELECTRICALLY
GROUNDED MET
COLD WATER PIP
(REMOVE PAINT,
RECEPTACLE
POWER SUPPLY CORD
*Cold water pipe must have metal continuity to
electrical ground and not be interrupted by
plastic, rubber or other electrically insulating
connectors (including water meter or pump)
without adding a jumper wire at these con-
nections.
B
ELECTRICAL
REQUIREMENTS
For 230 volt and 230/208 volt models with serial
plate amperes up through 12.0
Refer to Chart B for specific wiring and receptacle
information to be used.
OBSERVE ALL LOCAL GOVERNING CODES
AND ORDINANCES.
Do not, under any circumstances, remove the
power supply cord ground plug.
ELECTRICAL GROUND IS REQUIRED ON
THIS APPLIANCE.
A three-wire, single-phase 60 hertz AC only
electrical supply is required.
A separate electrical supply is required on a
separately fused circuit. Do not fuse ground-
neutral.
See Chart 6 for receptacle voltage require-
ments, proper fuse size, wire and wiring con-
nections which must conform with rating of
the appliance. Do
not use an extension cord.
Chart-B
PLUG AND
RECEPTACLE
DATA
RECEPTACLE
USE TIME-DELAY
FUSE
OR TIME
DELAY CIRCUIT
BREAKER
RATING IN
AMPS
da
@
15
RECEPTACLE
SERIAL PLATE
SERIAL PLATE
OF 230 VOLTS
SERIAL PLATE
MINIMUM
RECEPTACLE
I
TYPE
WIRE SIZE
OF BRANCH
CIRCUIT
SEE BELOW
.
1
14 GAUGE
I
SINGLE
OUTLET
USE COPPER
ONLY
WIRE ONLY
