5
STEP
Dual-Action
Axle Cover
Link Arm
Covers
Dual-Action
Arm
9
5
STEP
• On the right side, slide the dual-
action axle cover into place on the con-
sole mast axle. Slide a wavy washer
(25x34x2T) onto the axle. Slide the
right dual-action arm on the axle. Fix in
place with the washer (8x35x2T) and
locknut (M8). Cover with the included
nut cap.
• Make sure the sleeve is in place in
the socket joint of the lower link arm.
Connect the lower link arm to the dual
action arm with a screw (M8x30L).
Attach the washer (8x25x1.5T) and nut
(M8) to the end of the screw. Tighten
with the 5mm L-Shaped wrench and
13mm wrench.
• Position the link arm cover over the
joint of the lower link arm and secure
the two pieces of the cover together
with a panhead screw (M4x15L).
Connect the cover to each side of the
lower link arm with a washer
(5x10x1T) and screw (M5x10L).
• Repeat these steps on the left side.
BLACK BAG
