www.vikingtechnology.com
Table 4-2: Serial ATA Power Pin Definitions
Device Activity Signal (See note1)
Notes:
1) Remote LED is not implemented, pin 11 may be connected to GND to allow the ACTIVITY LED to remain
on to indicate a Power On condition when using a standard ATX type power supply.
4.3 Hot Plug Support
Hot Plug insertion and removal are supported in the presence of a proper
connector and appropriate operating system (OS) support as described in the
SATA 2.6 specification. This product supports Asynchronous Signal Recovery
and will issue an unsolicited COMINIT when first mated with a powered
connector to guarantee reliable detection by a host system without hardware
device detection.
5 Command Sets
5.1 ATA Commands
Table 5-1: Supported ATA Commands
Description
Description
Check power mode E5h Security Disable Password F6h
Data Set management 06h Security Erase Prepare F3h
DCO B1h Security Erase Unit F4h
Download Microcode PIO 92h Security Freeze Lock F5h
Download Microcode DMA 93h Security Set Password F1h
Execute drive diagnostic 90h Security Unlock F2h
Flush cache E7h Seek 70h
