A SERVICE OF

logo

4 Replacement Procedures 4.35 Fluorescent Lamp
Disassembly of Board Ass’y, Tape Adhesive, Sheets, Light guide, Cover Ass’y Bottom (L)
1. Disassembly of Board Ass’y1.
CAUTION: This process should be made in Clean room with no scratch nor particle on
Polarizer and B/L Ass’y.
2. Disassembly of Tape Adhesive2 used for Sheets fixing (4Points).
3. Disassembly of Sheets and Light guide3.
CAUTION: No penetration of foreign body is indispensable with any scratch on the
surface of each Sheet.
1. Disassembly of Screw (2Points) and Cover Ass’y4.
CAUTION: Maximum value of torque with Screw should be below 2.5kgf.
Figure 4-71 Replacing 14.1-inch LG fluorescent lamp (WXGA) (4)
4-114 [CONFIDENTIAL] TECRA M10 Maintenance Manual (960-685)