MONOGRAMMING AND EMBROIDERING - 1*
* USING AN EMBROIDERY HOOP (NOT SUPPLIED)
PREPARATION
Set the machine as illustrated opposite. (The “0” setting means the machine will
not feed the fabric leaving you to manoeuvre it freely yourself).
Remove the presser foot and the presser foot holder.
Attach the darning plate.
Lower the presser foot lever before starting to sew.
Adjust the stitch width according to the size of lettering or design.
OPERATION -1
Draw the desired lettering or design on the right side of the fabric.
Stretch the fabric between embroidery hoop as rmly as possible.
Place the fabric under the needle. Make sure the presser foot bar is down in its
lowest position.
Turn the balance wheel towards you to bring up the lower thread through the
fabric. Sew a few securing stitches at the starting point.
Hold the hoop with thumb and forengers of both hands while pressing the
material with the middle and third ngers and supporting the outside of hoop
with smaller nger.
STITCH LENGTH DIAL DARNING PLATE
Page 31
