Service Manual: E-TR and E-TRi
10
Preventive Maintenance Schedule
This section provides a comprehensive list of factory recommended PM requirements, along with
detailed procedures for performing each task.
DAI LY
WEEKLY
MONTHLY
AS NEEDED
Wipe down all surfaces including:
Display, handrails shroud and heart rate grips.
Clean under the running belt (soft cloth only)
Visually inspect running belt for alignment and tension
Ensure the power cord is not under the treadmill
Vacuum floor under and around treadmill
Inspect inside surface of running belt and top of deck
Correct any display or handrail squeaks and rattles
Visually inspect display panel (keypad) for wear
Vacuum inside shroud
Visually inspect the drive belt
Visually inspect the power cord for pinches or breaks
Wipe clean and lubricate elevation screws
Change belt and flip/new deck
Running belt & deck rewaxing*
* *
*Running Belt & Deck Rewaxing
The Pro Tread models 7600 and 7700 are equipped from the factory with a “Waxless” running belt
and deck system. It is not necessary to regularly wax, rewax or lubricate the running belt and deck.
Wax may be applied to alleviate running belt noise (see waxing instructions).
