Integrated USB 2.0 Compatible 4-Port Hub
Datasheet
Revision 2.3 (08-27-07) 14 SMSC USB2504/USB2504A
DATASHEET
RESET Input RESET_N IS This active low signal is used by the system to reset the
chip. The minimum active low pulse is 1us.
Self-Power /
Bus-Power
Detect
SELF_PWR I Detects availability of local self-power source.
Low = Self/local power source is NOT available (i.e., Hub
gets all power from Upstream USB VBus).
High = Self/local power source is available.
TEST Pins TEST[1:0] IPD Used for testing the chip. User must treat as a no-
connect or connect to ground.
Analog Test
&
Internal 1.8V
voltage
regulator
enable
ATEST/
REG_EN
AIO This signal is used for testing the analog section of the
chip, and to enable or disable the internal 1.8v regulator.
This pin must be connected to VDDA33 to enable the
internal 1.8V regulator, or to VSS to disable the internal
regulator.
When the internal regulator is enabled, the 1.8V power
pins must be left unconnected, except for the required
bypass capacitors.When the PHY is in test mode, the
internal regulator is disabled and the ATEST pin
functions as a test pin.
Table 4.4 Power, Ground, and No Connect
NAME SYMBOL TYPE FUNCTION
VDD1P8 VDD18 +1.8V core power.
If the internal regulator is enabled, then VDD18 pin 54
must have a 4.7μF (or greater) ±20% (ESR <0.1Ω)
capacitor to VSS
VDDAPLL3P3 VDDA33PLL +3.3V Filtered analog power for the internal PLL
If the internal PLL 1.8V regulator is enabled, then this pin
acts as the regulator input
VDDAPLL1P8 VDDA18PLL +1.8V Filtered analog power for internal PLL.
If the internal regulator is enabled, then this pin must
have a 4.7
μF (or greater) ±20% (ESR <0.1Ω) capacitor
to VSS
VDDIO3P3 VDD33 +3.3V I/O power.
VDDA3P3 VDDA33 +3.3V Filtered analog power.
VSS VSS Ground.
Table 4.3 Miscellaneous Pins (continued)
NAME SYMBOL TYPE FUNCTION
