12
Radio operations
BAND selection
Press the BAND / SUB button repeatedly to select your desired radio band during RADIO mode: FM1, FM2,
FM3, AM1, AM2. Each band can store 6 preset stations, for a total of 30 preset memory stations.
Tuning
In Radio mode turn the TUNE button to manually adjust the radio frequency. Rotate the button for 3 seconds
once and radio will seek the next strong and clear frequency station. Repeat to seek more stations in your
listening area with a strong signal.
Mono/ Stereo control (in FM radio mode)
Press the VOLUME knob / SEL button until the display shows ST ON or ST OFF (MONO). Turn the VOLUME
knob to switch between ON or OFF.
Improvement of reception of distant stations can be done by selecting MONO operation which may cut down
some reception noise.
Automatic store, Automatic scan
During listening to the radio press and hold the F / PS button for more than 3 seconds. The receiver will
automatically scan and save stations for the AM/FM bands.
· Press the F / PS button once in Radio mode to scan the stations in all bands.
Programming tuner stations
You can store up to a total of 30 radio stations in the memory (18 FM, 12 AM), manually or automatically.
- To store a station:
- Select a band (if needed).
- Select a station by 3/4 buttons.
- Press and hold a numbered button (1-6) which you want store the station for at least 2 seconds.
- To recall a station:
- Select a band (if needed).
- Press a Preset button (1-6) briefly to recall the stored station.
