116
Types of trouble and their solutions
Digital program editing does not
function.*
2)
Easy Dubbing does not function.*
1)
Others
Symptom Cause and/or Corrective Actions
• Your VCR and/or video camera recorder is not set
correctly.
c Make sure the input selector of the VCR is set to LINE.
Also,make sure the power switch of the video camera is
set to VTR/VCR. (p. 76)
• The IR SETUP code or PAUSE MODE is not set correctly.
c Select the correct IR SETUP code and PAUSE MODE,
according to your VCR. Then confirm VCR operation
with the IR TEST function. (p. 76)
• The input selector on the VCR is not set correctly.
c Set the selector correctly, and check the connection
between the VCR and your camcorder. (p. 83)
• The camcorder is connected to DV equipment other than
of Sony using the i.LINK cable (DV connecting cable).
c Keep the connection, and follow the procedure on
page 87.
• Setting program on a blank portion of the tape is
attempted.
c Set the program again on a recorded portion. (p. 91)
• The synchronization of your camcorder and the VCR is
not adjusted.
c Adjust the synchronization of the VCR. (p. 88)
• Your camcorder was connected to your computer with the
USB cable before installing the USB driver, so the driver
was not recognized by the computer.
c Uninstall the unrecognized driver, and then reinstall the
driver. (p. 99)
• The USB driver is not installed correctly.
c Uninstall the unrecognized driver, and then reinstall the
driver. (p. 99)
• Your computer’s operating system is Windows 98 or
earlier.
• The USB cable was not connected before starting up the
application software.
c Connect the USB cable before starting up the application
software. (p. 101)
• COMMANDER is set to OFF in the menu settings.
c Set it to ON. (p. 112)
• Something is blocking the infrared rays.
c Remove the obstacle.
• The batteries are inserted in the battery holder with the
+ – polarities incorrectly matching the + – marks.
c Insert the batteries with the correct polarity. (p. 141)
• The batteries are dead.
c Insert new ones. (p. 141)
USB Streaming function does not
work.*
3)
You cannot install the USB driver.*
3)
The Remote Commander supplied
with your camcorder does not
work.*
4)
