30-GB
Messages
If the following error messages flash in the display window, check the chart below.
Error message
BLANK
ERROR
FULL
EDIT
BUSY
HiDCin
HOLD
LoBATT
MEMORY
Meaning/Remedy
• An MD with no recording on it is inserted.
b Insert a recorded MD.
• The disc is damaged or does not contain proper recording or
editing data.
b Reinsert the disc. If this fails, rerecord.
• There is no more space to record on the disc (less than 12 seconds
available).
b Replace the disc.
• You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1700 letters for track or disc
names during playback or stop.
• You tried to enter a total of more than 500 letters for track or disc
names during a single recording.
b Enter the characters within the limit.
• The MD player is recording information (track start and end
position) from the memory to the disk.
b Wait until this process is completed. Do not expose the player
to physical shock, nor disrupt power supply.
• You tried to operate the recorder while it was accessing the
recorded data.
b Wait until the message goes out (in rare cases, it may take 2–3
minutes).
• Voltage of the power supply is too high (The supplied AC power
adaptor is not used).
b Use the supplied AC power adaptor.
• The recorder is locked.
b Slide HOLD against the arrow to unlock the recorder (page 17).
• Batteries are weak.
b Charge the rechargeable batteries or replace the dry batteries
(pages 23, 24).
• You tried to record when there is no indication in the display, with
the recorder placed where it receives continuous vibration.
b Put the recorder on a stable place, and start recording again.
