77
Messages
If the following messages appear in the display window on the recorder, check the chart
below.
Message Meaning/Remedy
AVLS NO
VOLUME
OPERATION
• AVLS is set to “On” and so the volume cannot rise higher.
, Set AVLS to “Off” (page 56).
BLANKDISC • A disc with no recording on it is inserted.
BUSY WAIT A
MOMENT
• The recorder is accessing disc information.
• You tried to operate the recorder while it was accessing the recorded data.
, Wait until the message goes out (in rare cases, it may take a few
minutes).
CANNOT EDIT • You selected, “Group Set”, “GroupRelease”, “Move”, or “Erase” while
recording.
• You tried to erase the track mark at the beginning of the first track or group.
• You tried to erase a track mark to combine tracks the recorder cannot
combine (a track recorded in stereo and in mono, for example).
• You tried to overwrite a track marks.
• You tried to change a title that includes characters the recorder cannot edit.
, Editing titles cannot be done if the title includes characters that cannot
be input on the recorder.
CANNOT
OPERATE
• You tried to press X or T MARK during synchro-recording.
CANNOT PLAY • You tried to play a track that is subject to play restrictions.
• You tried to play an MP3 track with a format not supported by this recorder.
, This recorder only supports MP3 tracks (MPEG-1 Audio Layer-3/
sampling frequency 44.1 kHz) that have been transferred using the
SonicStage software.
CANNOT
RECORD
• You tried to record on a disc that has already been recorded in MD mode.
, On this recorder, you cannot do additional recording on a disc that is
already recorded in MD mode. If you want to do additional recording
on such a disc, connect the recorder to a Windows computer and use the
supplied SonicStage or MD Simple Burner software.
CANNOT
RECORD OR
PLAY
• There is no audio data that can be played on the recorder.
• The audio data or disc management file has been damaged.
, Erase the whole disc (page 53) or perform the Format function
(page 55).
CANNOT SET • You tried to set “Time Mark” during synchro-recording.
• You selected “REC Level” while the recorder is not in recording-pause.
, Set “REC Level” while the recorder is in recording-pause.
• You tried to make the following settings while recording.
— Recording mode
— Disc Memory
— Play mode
— Selection of “Group REC” in menu
Charging • The rechargeable battery is being charged.
