Chapter 2 Fitting and Connections
26
Chapter 2 Fitting and Connections
Fitting the Lens
In the case of the DXC-D30F/D30PF/D30K/D30PK
model, the lens is already fitted. In other cases, use the
following procedure to fit the lens.
1
Remove the retaining rubber
which prevents the lens mount
from coming loose, then raise
the lens fixing lever, and
remove the lens mount cap.
2
With the lens fixing lever
turned fully counterclockwise,
push in the lens, aligning the
projection on the lens with the
cutout on the camera.
3
Supporting the lens, turn the
lens fixing lever fully
clockwise. Replace the
retaining rubber on the lens
mount.
Retaining rubber
Lens mount cap
Lens fixing lever
Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections
27
4
Using the triangular mark as a
guide, push the lens connector
into the LENS connector on
the camera head, until it clicks
into place. Fasten the cable
with the clamps.
LENS connector
Triangular mark
If using a lens with a 6-pin connector
This camera head has a 12-pin LENS connector. If the
lens cable has a 6-pin connector, fit an adaptor cable:
LO-612 (manufactured by Canon) or ECF-124
(manufactured by Fujinon) or equivalent.
Fitting optional filters
Loosen the lens hood fixing screw to remove the lens
hood, then attach the filter.
