DSR-200 U/C 3-858-622-22(1). E
8
Identifying the parts
$•
%¢
%∞
%•
%§
%¶
$ª
%º
%™
%£
#•
#¶
#ª
$º
$¡
$§
$¶
%¡
$¢
$∞
$™
$£
#¶ Eyecup
#• VIEW FINDER jack (p. 20)
#ª S VIDEO OUT jack (p. 34)
$º RFU DC OUT jack (p. 35)
$¡ DV IN/OUT jack (p. 73)
Connect DV products using the connecting
DV cable.
$™ CH-1 LINE/MIC switch (p. 64)
Set to change the audio source using a CH-
1 input.
$£ CH-1 ATT switch (p. 66)
Set ON to attenuate the CH-1 input
microphone level.
$¢ CH-2 LINE/MIC switch (p. 64)
Set to change the audio source using CH-2
input.
$∞ CH-2 ATT switch (p. 66)
Set ON to attenuate the CH-2 input
microphone level.
$§ MIC (PLUG IN POWER) jack (p. 28)
Connect an external mini jack type
microphone (not supplied). This jack also
accepts a “plug-in-power” microphone.
When using this jack, set LINE/MIC to
MIC FRONT.
$¶DIRECTION SELECT switch (p. 28)
Set to change the directionality of the built-
in microphone.
$•Built-in microphone (p. 64)
$ªMicrophone wind screen screw
Loosen to remove wind screen.
%ºMIC switch (p. 66)
Set ATT to attenuate the built-in
microphone and external microphone
connected to MIC (PLUG IN POWER) level.
%¡Lens hood screw
%™Power zoom button (p. 30)
%£PHOTO button (p. 45)
Press to shoot in photo mode.
%¢STANDBY (LOCK/STANDBY/PHOTO
STANDBY) switch (p. 26)
%∞START/STOP button (p. 26)
%§BUILT-IN MIC switch (p. 66)
If recording when there is a loud wind
using the built-in microphone, set to
WIND.
%¶AUDIO OUT/VIDEO OUT jacks (p. 34)
%•DC IN jack (p. 38)
