A SERVICE OF

logo

Open as PDF
next previous
CD-RW Recorder User’s Guide 3534 CD-RW Recorder User’s Guide
Symptom Possible Causes Solutions
• Short of PC
memory.
• “Auto thermal
re-calibration”
triggered.
• Defective CD-
R/RW media.
• Short of Hard Disk
capacity.
• Due to short of
main memory in
PC, swapping of
hard disc space
may have
occurred. If
swapped data from
the hard disc may
cut off causing
buffer under-runs.
• Increase main
memory capacity.
• Disable
“Auto thermal
re-calibration” in
the BIOS setup.
• Use another Hard
Disk if can not
disable it.
• CD-R/RW media
may be dirty,
scratched or
damaged. Rewrite
on another CD-
R/RW media.
• Generally 1.2 to 2
times the size of
the write data is
required. This may
vary according to
the write method.
Writing errors occur
(Buffer under-runs)
Symptom Possible Causes Solutions
• Bad connection
between IDE cable
and your CD-RW
drive.
• Conflicts with
other IDE devices.
• Using other
authoring software
which not supports
your CD-RW drive.
• Ensure that cables
or IDE connectors
are not damaged,
bent or dented.
Check especially
the pins.
• Ensure the
Master/Slave
device setting of
CD-RW if not
conflict with the
other IDE device
connected to the
same IDE port.
• Use the authoring
software provided
with your CD-RW
drive. When using
other software,
ensure your
CD-RW drive is
supported by
contacting the
software supplier.
No drive recognition.