11
CDX-M7850
2-586-657-21 (1)
H:\Data Disk\2586657211\258665721CDXM7850EUR\01GB02CD-EUR.fm masterpage:RightH:\Data Disk\2586657211\258665721CDXM7850EUR\01GB02CD-EUR.fm masterpage:Right
Other functions
Changing the sound settings
Adjusting the sound
characteristics
You can adjust the equalizer, DSO, bass, treble,
balance, fader and subwoofer volume.
1 Select a source, then press (SOUND)
repeatedly to select the desired item.
The item changes as follows:
EQ7 t DSO t BAS (bass) t
TRE (treble) t BAL (left-right) t
FAD (front-rear) t
SUB (subwoofer volume)*
* “ ∞” is displayed at the lowest setting, and can be
adjusted up to 20 steps.
2 Rotate the VOL control dial repeatedly
to adjust the selected item.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Note
Adjust within 3 seconds of selecting the item.
With the card remote commander
In step 2: press < or , instead of the VOL control
dial.
Adjusting the equalizer curve
— EQ7 Tune
You can adjust and store the equalizer settings
for different tone ranges.
1 Select a source, then press (MENU).
2 Rotate the SEEK control dial until
“Sound” appears, then press (ENTER).
3 Rotate the SEEK control dial until
“EQ7 Tune” appears, then press
(ENTER).
4 Rotate the SEEK control dial to select
the desired equalizer type, then press
(ENTER).
5 Rotate the SEEK control dial to adjust
the desired volume level.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
6 Press (ENTER) to move to the next
frequency.
The frequency changes as follows:
62Hz t 157Hz t 396Hz t 1.0kHz
t 2.5kHz t 6.3kHz t 16kHz
Repeat steps 5 and 6 to adjust the equalizer
curve.
The confirmation dialog appears after
adjusting “16kHz” and pressing (ENTER).
7 Rotate the SEEK control dial to select
“YES,” then press (ENTER).
The setting is complete and the display
returns to normal play/reception mode.
To restore the factory-set equalizer curve, press
and hold (ENTER) in step 5 or 6, then rotate the
SEEK control dial to select “YES.”
With the card remote commander
In steps 2, 3 and 5: press M or m instead of the SEEK
control dial; in steps 4 and 7: press < or , instead
of the SEEK control dial; in step 6: press < or ,
instead of (ENTER).
Adjusting menu items — MENU
1 Press (MENU).
2 Rotate the SEEK control dial until the
desired menu item appears, then
press (ENTER).
The items changes as follows:
Setup y Display y Receive Mode
y Sound y Edit y List
3 Rotate the SEEK control dial until
desired setting item appears, then
press (ENTER).
The digital indication moves to the right
(setting selection) side.
4 Rotate the SEEK control dial to select
the setting, then press (ENTER).
The setting is complete.
5 Press (MENU).
The display returns to normal play/reception
mode.
Note
Displayed items will differ, depending on the source
and setting.
With the card remote commander
In steps 2 and 3: press M or m instead of the SEEK
control dial; in step 4, press < or , instead of the
SEEK control dial.
continue to next page t
