Adjusting and Setting With Menus
STATUS Menu / DOWN CONVERTER Menu
36
STATUS Menu
The STATUS menu is used to display the settings
selected with the menus.
The STATUS menu consists of PAGE1 to PAGE5. This
menu only displays the current menu settings, and you
cannot change them with the menu.
PAGE1: Shows the settings selected with the
EXPOSURE and FOCUS menus.
PAGE2: Shows the settings selected with the COLOR
menu.
PAGE3: Shows the settings selected with the PAN TILT
ZOOM menu.
PAGE4: Shows the STEADY SHOT, IR-RECEIVE,
IMG-FLIP, REVERSE PAN, DISPLAY INFO,
COLOR BAR and FLICKER CANCEL settings
selected with the SYSTEM menu.
PAGE5: Shows the output settings of the output
connector on the camera, the firmware versions of
the BRC-H700 and BRU-H700 (if connected), etc.
DOWN CONVERTER
Menu
The DOWN CONVERTER menu is displayed only
when the HFBK-SD1 SD Interface Board is inserted
into the card slot of the camera.
D-SUB OUT1
Select the component signal output from the MONITOR
connector (D-sub 9-pin) on the HFBK-SD1 SD
Interface Board.
YPbPr: Outputs analog component signals.
RGB: Outputs RGB signals.
ADD SYNC
Appears when RGB is selected with D-SUB OUT1 and
specifies whether to add a sync signal.
RGB: Outputs each R, G and B signal with a sync signal
added.
G: Outputs the G signal with a sync signal added.
OFF: Outputs each signal with no sync signal added.
D-SUB OUT2
Select the output signal from the MONITOR connector
on the HFBK-SD1 SD Interface Board.
VBS: Outputs analog composite signals.
Y/C: Outputs S-video signals.
IMG-SIZE (image size)
Select the aspect ratio of the output signal.
16:9[LETTER]: The image is displayed in 16:9
letterbox.
4:3[CROP]: The image is displayed in 4:3 edge crop.
4:3[SQUEEZE]: The image is displayed in 4:3
squeeze.
SETUP
Select whether 7.5IRE setup is added to output signals.
ON: Outputs signals with 7.5IRE setup added.
OFF: Outputs signals with no 7.5IRE setup added.
<STATUS>
EXPOSURE
AE SPEED
AGC LIMIT
IRIS LIMIT
EX-COMP
BACK LIGHT
SPOT LIGHT
FOCUS
PAGE1
FULL AUTO
MID
18
dB
OFF
OFF 0
OFF
OFF
AUTO
<DOWN CONVERTER>
>D-SUB OUT1
D-SUB OUT2
IMG SIZE
SETUP
YP
bPr
VBS
16:9[LETTER]
OFF
