When the selected function is CD, playback and recording start simultaneously.
To stop recording, press the button.
To pause recording, press the button. (Applicable when the source is TUNER, VIDEO/AUX or MD.) To
resume recording, press again.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the Music Sensor function. (Applicable when the source is
TUNER, VIDEO/AUX or MD.)
1 Press the REC/REC MUTE button during recording or while in recording pause mode.
on the display flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press the button to resume recording.
To insert a blank space of less than 4 seconds, press the REC/REC MUTE button again while is
flashing.
To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press the REC/REC
MUTE button again. Each time the button is pressed, a 4-second blank space is added.
To erase a recording
Make sure the microphone is not connected to this unit.
1 Insert the tape to be erased into deck 2 and press the TAPE/DECK 1/2 button to display "TP 2".
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing the REV MODE button.
4 Press the REC/REC MUTE button to start the erasure.
RECORDING (cont.) pg. 14
DUBBING A TAPE MANUALLY
NOTE
• Set the tape to the point where recording will start.
• The reverse mode is automatically set to . Note that recording will be done on one side of the tape only.
