Guide the power cord between the
two pillar sections. Make sure the
smaller ends are facing the fan, then
snap the pillar sections together.
Align the pegs of one half of the base
with the holes in the other. Assemble
the base by sliding the halves together.
Guide the power cord through the
hole in the base.
Align the pegs on the base with the
hole at the bottom of the pillar and
attach the base to the pillar with the
large nut.
Attach the pillar and base assembly to
the fan and lock them in position by
sliding the four latching locks inward.
Run the cord through the groove at
the bottom of the base.
The Fan has five parts. Two tall pieces comprise the pillar and two
larger pieces are the base. The fan itself is the fifth part.
Assembly
Large Base Nut
Locks base to pillars.
Notch Key
Align by matching key
on pillar to notch/
groove on fan.
POWER
Toggles the unit ON and OFF.
IONS
Toggles the negative ionizer circuit ON/OFF.
SPEED
Adjusts the fan speed.
ROTATE
Switches between moving and stationary.
TIMER
Sets fan to operate for a period of time. Press
repeatedly to program the length of time the
unit should run. LED lights will indicate .5h, 1h,
2h and 4h. Example: The fan will shut off in
3.5 hrs. if .5h, 1h and 2h are simultaneously lit.
The buttons on the wireless remote and the control panel are
identical (except for the temperature feature) and correspond to
the same commands. Corresponding LEDs on the front panel
Illuminate to indicate settings.
Basic Operation
