53
Useful
Features
8
Fan Mode Setting
This function changes the fan rotation speed.
Selectable
items
Description
Normal Suitable for normal environments.
High Set when using the projector at
altitudes of approximately 1,200 meters
(4,000 feet) or more.
When “Fan Mode” is set to “High”, the fan rotation
speeds up, and the fan noise becomes louder.
9
STANDBY Mode
When set to “Eco”, power consumption is
reduced in Standby mode.
Selectable
items
Description
Standard The monitor output, LAN/RS232C and
Network functions are activated even if
the projector is in Standby mode.
Eco The monitor output, LAN/RS232C and
Network functions are switched off in
Standby mode.
0
STANDBY Audio Out
You can set audio output from the AUDIO
OUTPUT terminal of the projector that is in
Standby mode.
Selectable
items
Description
On The audio signal is output from the
AUDIO OUTPUT terminal in Standby
mode.
Off The audio signal is not output from the
AUDIO OUTPUT terminal in Standby
mode.
When “Eco” is selected for “STANDBY Mode”,
“STANDBY Audio Out” is set to “Off”
automatically and you cannot change the
setting.
•
Note
5
Setting the Lamp Mode
This function allows you to select the usage of
the two lamps installed in the projector.
Selectable items Description
Both Lamps Both lamps are used for greater
brightness.
Lamp 1 Only The lamp 1 is used.
When the lamp 1 burns out, the
lamp 2 automatically switches in
use.
Lamp 2 Only The lamp 2 is used.
When the lamp 2 burns out, the
lamp 1 automatically switches in
use.
Equal Use The lamp whose remaining life
time is the longer is used.
For lamp protection, this function is not
available for several minutes when changing
the lamp mode.
•
Note
6
Setting the Audio
You can set the following Audio items.
Selectable
items
Description
Volume You can change the volume level.
The adjustable range is 0 to 60.
Speaker On The audio signal is output
from the internal speaker.
Off
The audio signal is not output
from the internal speaker.
The audio signal is not output from the speaker
of the projector when the audio cable is
connected to the audio output terminal and you
cannot change the setting.
•
Note
Using the Ex. Setting
Select “Ex. Setting” and then press (ENTER)
to set “Fan Mode”,“STANDBY Mode”, “STANDBY
Audio Out”, “Filter Message”, “3D MODE”, “LAN/
RS232C” or “Network”.
Menu operation n Page
41
