43
Using memory card
Recording a motion picture
Use this setting to record images you are currently
watching.
Record with the settings made in “Rec. Mode” and
“Pre-recording”.
Press E REC to start recording.
• CARD indicator lights up red.
• Recording information displays in the lower
right corner of the screen.
1
2
Press E REC to stop recording.
To display the remaining record time.
Press DISPLAY while not recording.
• Remaining record time displays in the lower right corner
of the screen.
NOTE
• Do not press MAIN POWER on the display while
recording. Recording cannot finish properly and may
damage the file.
• Recording stops if you press POWER on the remote
control while recording.
• When card has no capacity for recording, “Card is full”
displays and stops recording.
• You cannot change the channel or switch the input source
while recording.
Displaying a motion picture
Press CARD and the card mode screen
displays.
1
2
Press c/d to select “Video”, and then press
ENTER.
3
Press a/b/c/d to select the file you want
to play, and then press ENTER.
• Video playback starts.
4
Press CARD again to display the operation
panel.
• See page 38 for the operation panel
information.
• When viewing a motion picture, by pressing
WIDE the picture size changes.
Small – Medium – Large.
NOTE
Broadcasting types or input signals not available for
recording:
1 COMPONENT input
2 Copy guarded signal
3 DVI-I input
Rec. Mode
Use this setting for recording images you are currently
watching. You can select the recording mode (picture
quality) for a motion picture.
5
6
Press a/b to select “Rec. Mode”, and then
press ENTER
Press MENU and the MENU screen displays.
2
3
Press c/d to select “Card”.
4
Press a/b to select “Video Setup” and then
press ENTER.
Rec. Mode
Pre-recording
Repeat
Edit
SP
LP
EP
Press a/b to select the desired mode, and
then press ENTER.
Press CARD and the card mode screen
displays.
1
CARD - VIDEO
PLAY
PLAY
MODE : SP
00:15:25
0001/0045 REPEAT:OFF
Selecting Video mode
Press CARD and the card mode screen
displays.
1
2
Press c/d to select “Video”, and then press
ENTER.
• When in CARD mode, press 0-9 or TV/VIDEO
to switch either TV or AV input mode.
LC-32/37G2X-f 04.5.22, 1:51 PM43
