2-19
CHAPTER2
MAKING COPIES Job memory
Deleting a stored job program
1
Follow steps 1 and 2 in “Storing a job program” on the
previous page. (1. Press the PROGRAM key. 2. Press
the “STORE/DELETE” key.)
2
Select the storage register number of the program to be
deleted.
●
Be sure to select a number which contains a stored program. If
not, “Storing a job program” operation will start.
3
Press the “DELETE” key or the “CANCEL” key.
●
If the “DELETE” key is pressed, the program will be deleted from
memory.
●
Press the “CANCEL” key to keep the program.
4
Press the “EXIT” key to exit the job memory mode.
Recalling a job program
1
Press the PROGRAM key.
●
The JOB PROGRAMS screen will appear on the touch panel.
●
The numbers which are highlighted are program numbers which
contain stored programs.
2
Select a stored program from 1 to 9 on the touch panel.
●
All selections stored in the program will appear on the touch
panel.
●
The recalled settings may be modified for a particular job run, but
any changes made will not be stored in the job memory. To store
the new settings, follow the “Storing a job program” procedure.
JOB MEMORY
JOB PROGRAMS
STORE/DELETE
RECALL
PRESS PROGRAM NUMBER.
EXIT
JOB PROGRAMS
JOB PROGRAM HAS BEEN ALREADY STORED.
STORE ANOTHER PROGRAM?
OR DELETE?
CANCEL DELETE STORE
STORE/DELETE
RECALL
PRESS PROGRAM NUMBER.
JOB PROGRAMS
STORE/DELETE
RECALL
PRESS PROGRAM NUMBER.
EXIT
JOB PROGRAMS
STORE/DELETE
RECALL
PRESS PROGRAM NUMBER.
EXIT
