930-112-01-B.00 PowerLogic
TM
EM4800 Series
01/2011 PowerLogic configuration tool
© 2011 Schneider Electric All Rights Reserved
19
Meter Points (Circuits) Tab The Meter Points (Circuits) tab contains the configuration information for
each of the metering points. It shows the number of elements used, the
phase, the current ratings, and the user-defined identification string for each
meter point. Default information is entered when the metering configuration
is selected in the Manufacturing Tab (see “Manufacturing Tab” on page 18).
Meter Point Configuration
The current rating and phase assignment for each meter point can be
configured individually, by meter, or all at once. The configuration in all three
cases does not take effect until the new settings have been sent to the meter
(see “Completing the Meter Configuration” on page 23).
To change the current rating and phase assignment for an individual meter
point:
1. Select one probe at a time from the Meter Points (Circuits) List. The
selected probe number will appear in the middle pane beside Probe,
and its assigned Current and Phase are shown beneath it. See Figure
13.
2. To change the Current, enter the required number. To change the
Phase, select the required phase type from the pull-down list.
Figure 13: Meter Points configuration screen
