64
safety and usage information
Radio frequency safety
The design of your phone complies with updated NCRP
standards described below. In 1991-92, the Institute of
Electrical and Electronics Engineers (IEEE) and the
American National Standards Institute (ANSI) joined in
updating ANSI’s 1982 standard for safety levels with
respect to human exposure to RF signals. More than
120 scientists, engineers and physicians from
universities, government health agencies and industries
developed this updated standard after reviewing the
available body of research. In 1993, the Federal
Communications Commission (FCC) adopted this
updated standard in a regulation. In August 1996, the
FCC adopted hybrid standard consisting of the existing
ANSI/IEEE standard and the guidelines published by the
National Council of Radiation Protection and
Measurements (NCRP).
Acknowledging special precautions and
Industry Canada notice
This equipment has been tested and found to comply
with the limits of a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation; if this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient / relocate the receiving antenna.
