104
•Protocol
: set the connection protocol used by the WAP browser:
WAP or HTTP.
•Home URL
: enter the URL address of the page to use as your
homepage.
• Gateway Address
: (WAP only) enter the gateway address of the
proxy server.
• Proxy Address
: (HTTP only) set the proxy server address and port.
• Secure Connection
: (WAP only) determines if the connection will
follow a secure protocol.
• Linger Time (sec.)
: set a time period (in seconds) after which the
network is disconnected if there has been no new data traffic in that
time.
• Advanced Settings
: allows you to configure some of the IP-specific
information.
–
Static IP
: specify if you want to manually enter an IP address. Remove
the check mark if you want the server to automatically assign the IP
address.
–
Local Phone IP
: enter the IP address obtained from the network
operator, if you checked the Static IP option.
–
Static DNS
: specify if you want to manually enter the Domain Name
Server (DNS) address. Remove the check mark if you want the server to
automatically assign the IP address.
–
Server 1/Server 2
: enter the Domain Name Server (DNS) addresses.
–
Traffic Class
: select the traffic class.
4. Press
OK
to exit Advanced Settings.
5. Press
Save
to save these settings.
The WAP settings may vary depending on the service provider.
