3-8
E
3-7
➜
Press
[Enter]
(CAMERA SET)
CAMERA ID OFF
V-SYNC INT
COLOR/BW AUTO...
MOTION DET OFF
ZOOM SPEED 3
DIGITAL ZOOM OFF
DISPLAY ZOOM OFF
DISPLAY P/T OFF
EXIT QUIT
❈ In AUTO mode, AGC will be displayed as “---“. You can’t adjust the
settings manually.
Caution : If you use an infrared light source while in AUTO mode, AUTO
switching malfunction and camera AF malfunction may occur.
(AUTO)
BURST ON
LEVEL LOW
DURATION S --|---- L
RET
➜
Press
[Enter]
MOTION DET
In MOTION DET, you can set the Motion Detection function, Motion Detection
Sensitivity, and the Area of Motion Detection. If the Motion Detection function
is set, the movement of an intruder can be detected. When motion is detected,
it sets off the Alarm signal of the Controller.
(CAMERA SET)
CAMERA ID OFF
V-SYNC INT
COLOR/BW COLOR...
MOTION DET ON...
ZOOM SPEED 3
DIGITAL ZOOM OFF
DISPLAY ZOOM OFF
DISPLAY P/T OFF
EXIT QUIT
(MOTION DET)
AREA PRESET...
SENSITIVITY
L ---|--- H
RET
Select ON and press [ENTER] and the MOTION DET additional menu will
appear. The AREA menu, selecting the screen area where the MOTION
detection function will be applied may be selected by PRESET or USER.
Set AREA to PRESET and the MOTION detection function will be applied to
the factory default part.
If you set the AREA menu to USER and press [ENTER], you may vary the
area and location of the area where you want to apply the MOTION detection
function by yourself. Press Left, Right, Up, or Down to select an area area.
Press ENTER and then Left, Right, Up, or Down to select a location. Press
ENTER again to move back to the upper menu.
Use [ENTER] and Left, Right, Up, or Down to move and scale the MOTION
detection area.
Press [ENTER] again and you will escape the AREA setup menu.
Use SENSITIVITY to set up the sensitivity of MOTION detection strength.
The higher, the more sensitive.
➜
Use the [Left,
Right, Up, Down]
Keys
AREA
LOCATION
❈
After PAN/TILT/ZOOM/FOCUS/IRIS movement finishes, MOTION DET
function will not work for about 5 seconds to stablize the chage of the
screen.
❈
MOTION detection function operates based on the brightness change
within the setup region. Therefore, erroneous operation may occur
depending on the brightness difference between the background and
the object that is being taken, or the status of the area setup, etc.
ZOOM SPEED
In the ZOOM SPEED menu you can select the speed of the ZOOM Key
(Tele/Wide).
Use the [Left] or [Right] keys in the ZOOM SPEED menu to select
the speed.
1 : Slowest speed
2 : Low speed
3 : High speed
4 : Fastest speed
AREA
LOCATION
00600A-SCC-C6407-ENG 8/17/06 3:27 PM ˘` 3-7
