
P
RINTING
F
ROM
DOS A
PPLICATIONS
D.6
Config Tab
You can configure various printer features.
• Emulation selects the emulation for printing a document.
The factory default is Auto.
• Power Save determines the length of time the printer waits
after a job is printed before it goes to a reduced power state.
If the printer is used frequently, select OFF which keeps the
printer ready to print with the minimum warm-up time. This
uses more power to keep the printer warm and ready to print.
• Auto Continue determines what action the printer should
take if the Multi-Purpose Tray is empty when a manual feed
print job is sent to the printer. If it is checked, the printer will
pick up the paper from the tray 1 after fifteen seconds.
Otherwise, the printer will wait for you to load paper in the
Multi-Purpose Tray.
• Jam Recovery determines what action the printer should
take when a paper jam occurs. If it is unchecked, the printer
does not reprint a page that has jammed. If it is checked, the
printer keeps the image in memory for a printed page until
the printer signals that the page has successfully printed. The
printer reprints all jammed pages.
• Toner save determines the toner quantity the printer should
use when printing. If it is checked, the printer conserves
toner when printing. The default value is unchecked, which
provides 100% usage.