Installation
Runco VX-22d Owner’s Operating Manual 37
PRE
L
IMINAR
Y
Connecting to AC PowerProjector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the VX-22d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110
VAC power
source.
3.8
Turning on the Power
1. Turn on your source components.
2. Turn on the main power switch at the rear of the projector.
3. Turn on the main power switch at the rear of the DHD Controller.
4. Press the ON button on the remote control – or the SOFT PWR button on the DHD
Controller front panel – to turn on the system. The vacuum fluorescent display on the
DHD Controller front panel briefly displays “Starting Display.”
5. When the projector is ready for use (after about 20 seconds), the RUN LED on the
DHD Controller front panel lights solid blue. The fluorescent display indicates the
current input source, aspect ratio and input resolution; for example:
3.9
Adjusting the Picture
Orientation
By default, the VX-22d is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or
inverted, you must change the picture orientation. To do this:
1. Press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
3. Select Display Device from the Service Menu.
4. Select Installation from the Display Device menu.
5. Choose Floor Rear, Ceiling Front or Ceiling Rear, to match the installation method.
The input voltage to the AutoScope lens motor must be between
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240
VAC power source!
Caution
VX-22d Component RCA
16:9 480I
Current Input Source
Aspect Ratio Input Resolution
You must enter a passcode to access the Service menu.
Note
