SECTION 2
INSTALLING THE PRINTER
7
Setting up the Feed
They printer’s feed systems is adjusted as follows:
1. Move the adjustable side guide so that the locking screws on the sheet separator
assembly are accessible.
2. Loosen the locking screw and raise the separator, then tighten the locking screw to
hold the separator in the up position. Repeat this step for all separators.
3. Place a single piece of media
under the separators and against
the fixed side guide.
On the separators that have media
beneath them; loosen the separator
locking screws, and let the
separators drop onto the media.
Then tighten the locking screws.
4. Position the adjustable side guide
so that it about 1/32-inch from the
sides of the media. Tighten the
locking screw on the side guide.
5. If not already present place a
single piece of media into the feed
area so it is starting to feed under
the separators. Then place
additional media into the feed area;
making sure the media stack is
fanned so the bottom piece is
closest to the separation point.
IMPORTANT
Be sure that unused separators are
locked in their raised position. If not,
they will rub on the feed rollers,
causing transport problems and
damage to the rollers and separators.
