30 Printing Using a PC
Top of Form (TOF)
This setting allows you to fine tune the print starting position
on your label stock. This will be factory calibrated. If fine tun-
ing is needed, increase this value to move the image down on
the label. Decrease this value to move the image up the label.
The unit of measure is 0.1mm.
Click the Test button to send a test
print to the printer that will help
you adjust the TOF and Left
Margin Offset. The printer will
print the pattern shown. Adjust
the values so that both black bars
print on the label with no white
space on the label and no ink on
the liner.
Tear Off Position
If Output Mode (described earlier in this section) is set to
Present, the printer will present your labels over the Tear Bar
for easy removal. This tear off position is set at the factory.
If fine tuning is needed to align the break in your label stock
over the Tear Bar, increase this setting to eject the label further;
decrease this setting to eject the label stock less. The unit of
measure is 0.1 mm.
Cut Position
If a label cutter attachment is connected to the printer you can
fine tune the cut position between the labels. Increase this
value to move the label further out before the cut; decrease
this value to eject the label stock less before the cut.
+
+
-
-
LEFT OFFSET
TOF
(10 units)
1.0 mm
511203.qxd 8/7/2008 2:22 PM Page 30
