13
LFE/SUBWOOFER IN - Use this input only
if you have a Dolby Digital system and
know your Subwoofer output jack is low
pass filtered (Fig. 7 previous page).
If the Subwoofer output jack is unfil-
tered, connect the subwoofer output
jack to any unused Line Level In jack
(Fig. 8). In either case, with Dolby
Digital systems, select Subwoofer as
“on” or “yes” in the “speaker set up” or
“bass management” function of your
electronics. Read the owner’s manual of
your electronics to learn how to select
this setting.
FIGURE 8.
HOW TO TELL IF YOUR SUBWOOFER
OUTPUT JACK IS FILTERED OR NOT
Use the “speaker set-up” or “bass
management” function of your
Dolby Digital processor to select
Subwoofer as “on” or “yes.” Connect
the Subwoofer output jack to the
“LFE/Subwoofer” input of the
PSW1200. Disconnect the other
speakers in the system so that all
you can hear is the Subwoofer. Play
music or a movie with vocal content.
If you can hear and understand the
words, your output jack is
not fil-
tered. If all you can hear is bass, and
the vocals are barely or not at all
audible, your Subwoofer input jack
is
filtered.
