English
31
Headphone
4 Insert the plug into the headphone socket n at the front of the TV.
4 Press c on the remote control to switch off the internal loudspeakers of
your TV.
The headphone socket has an impedance of between 8 and 4000 Ohm and is of
the 3.5 mm jack type.
In the
SOUND menu select Headphone to adjust the headphone volume and
balance and to select the audio source for your headphone sound. See p. 15.
Extra loudspeakers
To achieve a better sound effect you can connect 2 or 4 extra loudspeakers,
min. 8 Ohm. See also Spatial and Surround Sound, p. 15.
4 Connect the loudspeakers to the connector clips at the back of the TV.
4 Push the connector clip down and insert the ends of the wires into the
openings : the negative wires (usually the darkest ones) to the black connector
clips, the positive wires to the red connector clips. On the back of the TV it is
indicated where you connect the
FRONT and REAR loudspeakers.
Do not insert the wires too far.
In case of 2 extra loudspeakers :
In case of 4 extra loudspeakers :
4 Connect them to REAR and FRONT.
4 Press the loudspeaker switch on the back of the TV in the c position.
5 The internal loudspeakers of your TV are now switched off.
4 Connect them to FRONT.................................
4 Connect the front left loudspeaker to
FRONT L, the front right loudspeaker to
FRONT R.
4 Put the loudspeaker switch on the back of
the TV in the
c position.
5 The internal loudspeakers of your TV are
now switched off.
5 You achieve a better front sound effect.
4 Connect them to REAR.
4 Connect the rear left loudspeaker to
REAR L, the rear right loudspeaker to
REAR R.
5 You achieve a surround sound effect.
A loudspeaker kit to achieve Surround
Sound, containing two extra boxes only to
be connected to
REAR and 12 m wire can
be purchased from your dealer.
Do never connect the loudspeakers from
this kit to
FRONT.
or
