A SERVICE OF

logo

Open as PDF
next previous
C3425M-E (1/09) 13
2. Pull the video and power wires to the selected ceiling tile.
3. Mount the unit to the ceiling tile (refer to Figure 6 and Figure 7):
a. Remove the ceiling tile from the ceiling.
b. Cut a hole 4 inches (10 cm) in diameter in the ceiling tile.
c. Use one of the following mounting options:
• To mount with the adapter plate, place the adapter plate on the inside of the ceiling tile
(refer to Figure 6).
Figure 6. Ceiling Tile Installation with Adapter Plate
• To mount with the surface mount ring, turn the ring upside down and place it on the
inside of the ceiling tile (refer to Figure 7).
Figure 7. Ceiling Tile Installation with Surface Mount Ring
d. Attach the back box to the ceiling tile and the adapter plate or surface mount ring with two
10-32 x 1.50-inch Phillips pan head self-tapping screws (supplied).
e. Reinstall the ceiling tile with the unit.
CEILING
TILE
BACK BOX
10-32 X 1.50-INCH
PHILLIPS PAN
HEAD SCREWS
(SUPPLIED)
ADAPTER PLATE
(SUPPLIED)
SURFACE MOUNT RING
CEILING
TILE
BACK BOX
10-32 X 1.50-INCH
PHILLIPS PAN
HEAD SCREWS
(SUPPLIED)